Plastic panelling - graphite

Product detailed description

Board dimensions: 300 x 10 x 0.9 cm (l x w x h). Sold in packs of 3m² – 10 pcs per pack.
Many colors and a wide selection of finishing profiles for an ideal cladding appearance.
Minimal maintenance required without surface treatment.
Simple, quick, and dry installation.
Modern Design, Low Weight, Affordable Price.
Quick and Easy Installation.
Good Thermal Insulation Properties.

• Plastic cladding panel with tongue-and-groove system for easy and quick installation.

• Primarily used for cladding roof soffits, gables, and entire facades, as well as interiors.

• The cladding is also very suitable for dusty and humid areas .

• The cladding is easily combinable with insulation systems.

• Thanks to the so-called chimney effect, it solves problems with damp masonry

Instructions for using plastic panels:
• Installation of outdoor cladding is not recommended due to the fragility of the material at
temperatures of +5°C and below. This creates a risk of material damage during installation.
• When installing horizontal edge profiles on the lower part of the clad area
we recommend always drilling drainage holes in the lower part of these profiles from below so that
the best water drainage through these profiles is ensured.
• Dark cladding should not be used in places exposed to
direct sun, as high heat radiation can cause deformation of dark
claddings. Such damage cannot be claimed. For other color shades
direct sunlight can cause a 15% loss of cladding color (this does
not apply to cladding panels with Renolit foil).
• Deformation of claddings due to high heat radiation can be prevented by installation using
mounting clips (free movement of slats) and ventilation profiles, which are recommended for use in the upper and
lower part for better ventilation of overheated air.