Plastic wall panel - marble, textured - 2nd quality

Product detailed description

Class II includes panels with minor visual defects, imperfections, surface inaccuracies... e.g. dots, grooves, and slight waviness on the sides of the cladding (tongue-and-groove). This is not a type of defect that hinders installation. This is not a type of defect that hinders installation.

Cladding panel dimensions: 300 x 10 x 0.9 cm (l x w x h). In a package of 3m² – 10 pieces per package.
Minimal maintenance required without surface treatment.
Simple, quick, and dry installation.
Modern design, low weight, affordable price.
Quick and easy installation.
Good thermal insulation properties.

• Plastic cladding panel with tongue-and-groove system for easy and quick installation.

• It is mainly used for cladding roof soffits, gables, and entire facades, as well as for interiors.

• The cladding is also very suitable for dusty and humid areas.

• The cladding is easily combinable with insulation systems.

• Thanks to the so-called chimney effect, it solves problems with damp masonry

Instructions for using plastic cladding panels:
• Installation of outdoor cladding is not recommended due to the fragility of the material at
temperatures of +5°C and below. This creates a risk of material damage during installation.
• When installing horizontal edge profiles on the lower part of the clad area
we recommend always drilling drainage holes in the lower part of these profiles from below so that
the best water drainage through these profiles is ensured.
• Dark cladding, e.g. dark wood, should not be used in places exposed to
direct sun, as high heat radiation can cause deformation of dark cladding.
claddings. On such damage, no claim can be made. For other color shades,
direct sunlight can cause a 15% loss of cladding color (this does not apply to cladding panels with Renolit film).
not apply to cladding panels with Renolit foil).
• Deformation of claddings due to high heat radiation can be prevented by installation using
mounting clips (free movement of slats) and ventilation profiles, which are recommended for use in the upper and
lower part for better ventilation of overheated air.